Setup - Toro 41593 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
Media and Additional Parts
Description
Ignition key
Operator's Manual
Engine owner's Manual
Parts Catalog
Operator Training Materials
Note: Determine the left and right sides of the machine from the normal operating position.
Note: If you have questions or need additional information regarding the spray control system, refer to the Operator's Manual
supplied with the system.
Important: This sprayer is sold without nozzles and a controller. Either a Manual Spray Operation Kit or
ProControl ™ ™ ™ XPKit is necessary for the proper function of the machine.
To use the sprayer, you must obtain and install nozzles . Contact your Authorized Toro Distributor for information
on the available boom kit and accessories.
After you install your nozzles and before using the sprayer for the first time (if you do not use Pro Control™ ™ ™ XP Spray
System), adjust the boom bypass valves so that the pressure and application rate remains the same for all booms
when you turn one or more booms off. Refer to Calibrating the Boom Bypass Valves section in the Operation section.
Description
No parts required
Qty.
–
Qty.
2
1
Read the manuals and watch the training materials before
1
operating the machine.
1
1
12
Use
Check the boom hinge springs.
Use