Safety; Safe Operating Practices; Chemical Safety - Toro 41593 Operator's Manual

Safety

Improper use or maintenance by the operator or owner can
result in injury. To reduce the potential for injury, comply
with these safety instructions and always pay attention to the
safety alert symbol, which means CAUTION, WARNING, or
DANGER-"personal safety instruction." Failure to comply
with the instruction may result in personal injury or death.
Supervisors, operators, and service persons should be familiar
with the following standards and publications: (The material
may be obtained from the address shown).
•
Flammable and Combustible Liquids Code:
ANSI/NFPA 30
•
National Fire Protection Association:
ANSI/NFPA #505; Powered Industrial Trucks
National Fire Prevention Association
Barrymarch Park
Quincy, Massachusetts 02269 U.S.A.
•
SAE J2258 Light Utility Vehicle
SAE International
400 Commonwealth Drive, Warrendale, PA
15096-0001, U.S.A.
•
ANSI/UL 558; Internal Combustion Engine Powered
Industrial Trucks
American National Standards Institute, Inc.
1430 Broadway New York, New York 10018 U.S.A.
or
Underwriters Laboratories
333 Pfingsten Road
Northbrook, Illinois 60062 U.S.A.

Safe Operating Practices

WARNING
The sprayer is an off-highway vehicle only and is
not designed, equipped, or manufactured for use on
public streets, roads, or highways.
Supervisor's Responsibilities
•
Make sure that operators are thoroughly trained and
familiar with the Operator's Manual, engine owner's manual,
and all labels on the sprayer.
•
Establish your own special procedures and work rules
for unusual operating conditions (e.g. slopes too steep
for sprayer operation).

Chemical Safety

WARNING
Chemical substances used in the spray system may
be hazardous and toxic to you, bystanders, animals,
plants, soils or other property.
• Carefully read and follow the chemical
warning labels and Material Safety Data
Sheets (MSDS) for all chemicals used, and
protect yourself according to the chemical
manufacturer's recommendations. For example,
use appropriate Personal Protective Equipment
(PPE) including face and eye protection, gloves,
or other equipment to guard against personal
contact with the chemical.
• Keep in mind that there may be more than 1
chemical used, and information on each should
be assessed.
• Refuse to operate or work on the sprayer if this
information is not available!
• Before working on a spray system, make sure
that the system has been triple rinsed and
neutralized according to the recommendations
of the chemical manufacturer(s) and that all of
the valves have been cycled 3 times.
• Verify that there is an adequate supply of clean
water and soap nearby, and immediately wash
off any chemicals that contact you.
•
Obtain proper training before using or handling
chemicals.
•
Use the correct chemical for the job.
•
Follow the chemical manufacturer's instructions for the
safe application of the chemical.
•
Handle chemicals in a well ventilated area.
•
Wear goggles and other protective equipment as
instructed by the chemical manufacturer. Ensure that as
little skin as possible is exposed while using chemicals.
•
Have clean water available especially when filling the
spray tank.
•
Do not eat, drink, or smoke while working with chemicals.
•
Always wash your hands and other exposed areas as soon
as possible after finishing the work.
•
Properly dispose of unused chemicals and chemical
containers as instructed by the chemical manufacturer
and your local codes.
•
Chemicals and fumes in the tanks are dangerous; never
enter the tank or place your head over or in the opening.
4