Storage - Toro 41593 Operator's Manual

Figure 68
1. Suction hose
3. Disconnect the hose from the tank (Figure 68).
4. Pull the suction strainer out of the hole (Figure 69).
Figure 69
1. Suction strainer
5. Clean the suction strainer with clean running water.
6. Replace the suction strainer, seating it fully into the
hole.
7. Connect the hose to the top of the tank and secure
it with the retainer.
2. Retainer

Storage

1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Clean dirt and grime from the entire machine, including
the outside of the engine's cylinder head fins and
blower housing.
Important: You can wash the machine with mild
detergent and water. Do not use high pressure
water to wash the machine. Pressure washing
may damage the electrical system or wash away
necessary grease at friction points. Avoid excessive
use of water, especially near the control panel,
lights, engine, and the battery.
3. Clean the spray system; refer to the Cleaning section.
4. Clean the pistons in the valve assembly as follows:
A. Position the valves in the Off position (shaft close
to the hose barb).
Note: Make sure that there is no water in the
tubing.
B. Remove the 3 forks securing the valve seats to the
valve assembly (Figure 70).
1
2
3
4
1. Valve assembly
2. Fork
3. Valve piston
C. Remove the 2 screws and nuts securing the
hose-loom bracket to the sprayer frame (Figure
70). Lower the hoses away from the valve
assembly.
54
6
5
g017893
Figure 70
4. Valve seat
5. Hose-loom bracket
6. Spring