Toro 41593 Operator's Manual page 17

1
1. Hour Meter location
Sprayer Controls
1. Oil pressure and battery
light
2. Water temperature and
glow plug light
3. Pressure gauge
Application Rate Switch
The application rate switch is located on the dash to the right
of the steering wheel (Figure 13). Press and hold the switch
forward to increase the spray system pressure, or press and
hold it rearward to decrease pressure.
Pressure Gauge
The pressure gauge (Figure 11) is located on the dash. This
gauge shows the pressure of the fluid in the system in psi
and kPa.
G013747
Figure 10
g018929
Figure 11
4. Application rate switch
5. Dash controls for optional
kits
6. Ignition switch and key
Master Boom Switch
The master boom switch is located on the floor board of the
machine cab and to the left of the operator. It allows you to
start or stop the spray operation. Press the switch with your
foot to enable or disable the spray system (Figure 12).
1. Master boom switch
Boom Switches
The boom switches are located on the control panel to the
right of the seat (Figure 13). Toggle each switch forward to
turn the corresponding boom section on and rearward to
turn them off. When the switch is turned on, a light on the
switch illuminates. These switches will only affect the spray
system when the master boom switch is on.
Pump Switch
The pump switch is located on the control panel to the right
of the seat (Figure 13). Toggle this switch forward to run
the pump or rearward to stop the pump. When the switch is
turned on, a light on the switch illuminates.
Important: Only engage the pump switch when the
engine is at low idle to avoid damaging the pump drive.
Boom Lift
The boom lift switches are located on the control panel to the
right of the seat and used to raise the left and right booms
respectively (Figure 13).
17
Figure 12