Door Stop Adjustment; Light Bulb; Door Hinge Adjustment - Viking VDSC367 Service Notebook

Door Stop Adjustment

Your refrigerator is factory set at 110° door
stop position. To change to either the 90°
or 120° position, remove the door stop pin
located in the bottom hinge using a 3/16"
allen wrench. For 120° swing, move the pin
to stop hole closest to the unit. For 90° swing,
move pin to stop hole farthest from the unit.

Light Bulb

Disconnect power at breaker or turn power
disconnect switch to the off position. Lightly
grasp light cover with both hands and pull
down. Replace bulb with an incandescent,
medium base tubular bulb with a maximum
of 40 watts. Replace cover by engaging light
bracket with the back fingers on the light
cover. Once engaged, snap the front fingers
on the light cover.
Note: The clear section of the light cover
is considered the back section. Reconnect
power or turn power disconnect switch to the
"ON" position.

Door Hinge Adjustment

Removal of the upper grill assembly allows
access to door hinge for adjustment.
©2012 Viking Preferred Service
Door stop
pin
Service Procedures
To remove upper grill:
1a. (Professional) Lift center grille louver up
and pull out.
1b. (Designer) Pull the center grille louver up
at an angle and pull out.
2. Using an 8" magnetic nut driver, remove
the two 1/4" screws.
43