Table of Contents
Advertisement
Door Replacement and Adjustment
1
Reattach door to range.
3
Remove pins from holes in hinges.
5
If the door needs to be adjusted, loosen hinge trim screws
located in Step 2. Adjust the screws located between the
door and kickplate using a 5/32" hex head Allen wrench.
After adjustment, tighten hinge trim screws.
24
2
1
Open door completely. Reattach
hinge trim on both sides.
4
Close door.
Final Preparation
• All stainless steel body parts should be
to remove encrusted materials, soak with hot,
wiped with hot, soapy water and with a
wet cloths to loosen the material, then use a
liquid cleaner designed for this material.
wool or nylon scraper. DO NOT use a metal
If buildup occurs, DO NOT use steel wool,
knife, spatula, or any other material tool to
abrasive cloths, cleansers, or powders!
scrape stainless steel! Scratches are almost
If it is necessary to scrape stainless steel
impossible to remove.
Performance Checklist
□ Check self-clean function—door will lock in
A qualified installer should carry out the
following checks:
□ Check top burner
1-1/2"
ignition. See
(3.8 cm)
drawing for proper
flame height on HI.
3/8"
The low flame should
(0.95 cm)
light at every port.
□ Check oven bake function—bake element
When conducting performance test,
on full power, center and outside broil
DO NOT run self-clean cycle for more
elements at partial power.
than 10 minutes with oven racks inside
oven. This could cause them to discolor
□ Convection bake function—bake and broil
due to the high temperature required
for self-cleaning.
elements the same with the convection fan
on.
□ Check TruConvec™ function—TruConvec
element (behind convection fan cover) on
and convection fan on.
□ Check HI broil function–both broil
elements at full power.
□ Check LOW broil function—inner broil
element only.
□ Check convection broil function—both
broil elements at full power with convection
fan on.
25
approximately 30 seconds, the center and
outside broil elements will turn on and the
bake element will turn on at partial power.
Check broil elements through window to
make sure they are on, then abort
self-clean cycle to unlock door.
NOTICE
Advertisement
Table of Contents
