Showroom Mode; Sabbath Mode; Fahrenheit To Celsius - Viking VDSC367 Service Notebook

Hide thumbs Also See for VDSC367:
Table of Contents

Advertisement

Showroom Mode

Showroom mode allows electronic controls and
interior lights to function independently of the
refrigeration system.
To enter Showroom mode:
ACTIVATE
Press and hold the "ACTIVATE
CONTROLS
CONTROLS" pad. While holding,
press and hold the "HIGHER" and
"ALARM OFF" pad simultaneously.
Continue holding until three beeps
HIGHER
are heard and then "SHOW" is
illuminated along with Refrigerator
and 38
F or Freezer and 0
O
Whichever section was active
ALARM
prior to to showroom mode being
OFF
entered will determine which one is
displayed.
To exit Showroom mode: Press and hold the
"ACTIVATE CONTROLS" pad. While holding,
press and hold the "HIGHER" and "ALARM
OFF" pad simultaneously. Continue holding
until three beeps are heard. The display will
revert to normal operation

Sabbath Mode

To enter Sabbath mode, press and
hold "ACTIVATE CONTROLS" pad
then press and hold "DISPLAY
OFF" pad, together for three
seconds this will cause an audible
three beeps, signifying that
Sabbath mode has been entered.
When Sabbath mode has been entered the
display goes blank except for the "SAB",
see illustration below, which will remain
illuminated whether the door(s) are open or
closed, it will not change state.
©2012 Viking Preferred Service
Sabbath mode is used to control the
refrigerator without interior lights, LED
display changes and enunciators. Alarms are
suppressed, you will not get visual or audible
alarms during Sabbath mode, although they
are recorded in memory and will be displayed
upon exiting Sabbath mode.
The freezer/refrigerator outputs (compressor,
F.
O
fans,etc.) should not have an immediate
reaction from a user action. If the control calls
for an action because the door was opened
or closed, the control shall delay its reaction
randomly (15-25 seconds).
To exit "SABBATH" mode, press and hold
"ACTIVATE CONTROLS" and then "DISPLAY
OFF" together for three seconds, an audible
three beeps will be heard and "SAB" on
display will extinguish. The display will return
to normal and any alarms will be visually and
audibly displayed.

Fahrenheit to Celsius

Factory default for readout is
Fahrenheit, to change to Celsius,
HIGHER
press and hold "ACTIVATE
CONTROLS" and then press and
hold "DISPLAY OFF" for three
ACTIVATE
seconds and
CONTROLS
To change back to Fahrenheit,
repeat same steps.
DISPLAY
OFF
Operation
F will change to
C.
o
o
ACTIVATE
CONTROLS
DISPLAY
OFF
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fdsb5421Vcsb5421Fdsb5481

Table of Contents