Program Mode C; Set Model Type; Adjust Freezer Upper Temperature Limit; Adjust Freezer Lower Temperature Limit - Viking VDSC367 Service Notebook

Program Mode C

If you are not already in Mode B, go back to
Mode B instructions on Page 34.
Once you are in Mode B (Prb in
display), press and hold "ALARM
OFF" for three seconds and
display will change to "PrC",
signifying that control is now in Program
Mode C, see illustration below.

Set Model type

While in Mode C, press and
release, either "FRZ TEMP or
REF TEMP" to display the current
model type setting, a three digit
number in the display.
Pressing and releasing either
"HIGHER or LOWER" pads
will allow you to change model
types until you get to the proper
three digit number for your unit,
seeTable 1 on Page 42 Set the
correct model code from table
below.
Model code
Model
5421
5481
The "REFRIGERATOR and/or FREEZER"
indicators will illuminate for each model type
as it is selected depending upon the model
configuration. (example: code 430 will only
illuminate the "REFRIGERATOR" indicator
because it is an All Refrigerator)
©2012 Viking Preferred Service
ALARM
OFF
FRZ
TEMP
REF
TEMP
HIGHER
LOWER
Value
342
348
Service Procedures
Setting the model code is required
whenever the low voltage board is
replaced, this will update all of the settings
indicated in Table 1 on Page 42 for the
model you select. With this setting you can
program all necessary settings with one
input for the appliance.

Adjust Freezer Upper Temperature Limit

While in Mode C, press and hold
"MAX FRZ" and and then hold the
"HIGHER" pad for three seconds,
this will result in the display
changing to "FUL".
Pressing and releasing "HIGHER
and LOWER" pads will increase
or decrease the set point, which
should be set at 7 F.
o

Adjust Freezer Lower Temperature Limit

While in Mode C, press and hold
"MAX FRZ" and and then hold the
"LOWER" pad for three seconds,
this will result in the display
changing to "FLL".
MAX
FRZ
HIGHER
HIGHER
LOWER
MAX
FRZ
LOWER
37