Final Installation; Door Replacement And Adjustment - Viking VESC530-4B Installation Manual

Anti-tip Device Installation
(cont.)
4
1
Attach bracket with
mounting hardware provided.

Final Installation

Note: Refer to range electrical
requirements section for proper
installation information.
2
Slide range into place. Be sure anti-tip
and front to back. The side trim must be 3/8" (0.95 cm)
bracket slides into the anit-tip opening.
20
1
Connect electrical in shaded area. See the "Electrical
Requirements" section for more information.
3
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
above countertop. If unit is not level repeat steps 5-7
of "Leveling/Adjustments/Alignment" section.

Door Replacement and Adjustment

1
Reattach door to range.
3
Remove pins from hole in hinges.
5
If the door needs to be adjusted, loosen hinge trim screws (see step 2).
Adjust the screws located between the door and kickplate using a 5/32"
hex head allen wrench. After adjustment, tighten hinge trim screws.
2
1
Open door completely. Reattach hinge trim.
4
Close door.
21