Side-Discharging The Clippings - Toro TurfMaster 22205TE Operator's Manual

Mowing with the Grass Bag
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
Removing the Grass Bag
To remove the bag, reverse the steps in Installing the Grass
Bag above.
DANGER
The machine can throw grass clippings and
other objects through an open discharge tunnel.
Objects thrown with enough force could cause
serious personal injury or death to the operator or
bystander.
Never open the door on the discharge tunnel when
the engine is running.

Side-discharging the Clippings

Use the side discharge for cutting very tall grass.
WARNING
The blades are sharp; contacting the blades can
result in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
DANGER
An uncovered discharge opening will allow objects
to be thrown in the direction of the operator or
bystanders. Also, contact with the blades could
occur. Thrown objects or blade contact can cause
serious injury or death.
Never operate the machine without the
side-discharge deflector or side-discharge chute in
place and working properly.
Installing the Side-discharge Chute
Important: Ensure that the rear-discharge plug is in
place before you recycle the clippings.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the grass bag if it is installed on the machine;
refer to Removing the Grass Bag (page 14).
3. Insert the rear-discharge plug; refer to Recycling the
Clippings (page 13).
4. Remove the side-discharge deflector by pulling up
on the spring that holds the deflector in place and
removing the deflector (Figure 20).
1. Top of the side-discharge
deflector
2. Spring
5. Install the side-discharge chute (Figure 21) by pulling
up on the spring, placing the chute over the opening,
and lowering the spring over the tabs on top of the
discharge chute.
1. Side-discharge chute
Removing the Side-discharge Chute
To remove the side-discharge chute, reverse the steps in
Installing the Side-discharge Chute.
14
1
2
G019649
Figure 20
3. Side-discharge deflector
1
g019647
Figure 21
3