Checking The Condition Of The Belts; Emptying The Fuel Tank And Cleaning The Filter; Changing The Fuel Filter; Servicing The Blade-Drive System - Toro TurfMaster 22205TE Operator's Manual

Checking the Condition of the
Belts
Service Interval: Every 50 hours
1. Stop the engine and wait for all moving parts to stop.
2. Remove the belt cover (Figure 5) by removing the 4
bolts that hold it to the machine housing.
3. Check the belts for any cracks, frayed edges, burn
marks, or any other damage.
4. Replace all damaged belts.
5. If you replace the blade-drive belt, you must adjust it.
Refer to Changing the Blade-drive Belt (page 24).
6. Install the belt cover with the 4 bolts that you removed
in step 2.
Emptying the Fuel Tank and
Cleaning the Filter
Service Interval: Every 50 hours—Check the fuel hose and
replace it if necessary.
Every 100 hours—Clean the fuel tank filter.
Yearly or before storage—Empty the fuel tank before
repairs as director or before storage.
Note: The fuel tank filter (screen) element is located inside
the fuel tank at the outlet. This filter is a part of the fuel tank
and cannot be removed.
1. Stop the engine and wait for it to cool down.
Important: Drain gasoline from a cold engine
only.
2. Disconnect the wire from the spark plug.
3. Close the fuel shutoff valve.
4. Disconnect the fuel line by loosening the tube clamp at
the carburetor.
5. Open the fuel shutoff valve and drain the gasoline
completely from the tank and fuel line into an approved
fuel container.
6. Remove the fuel tank from the machine.
7. Pour a small amount of fuel in the fuel tank, move
the fuel around in the tank, and pour it out into an
approved fuel container.
8. Install the fuel tank and the fuel line.

Changing the Fuel Filter

Service Interval: Every 100 hours
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Close the fuel shutoff valve (Figure 27).
1
g019650
1. Fuel filter
4. Remove the fuel filter (Figure 27) from the fuel line by
loosening the tube clamps surrounding the fuel filter.
5. Install a new fuel filter in the fuel line using the tube
clamps that you removed in step 4.
Servicing the Blade-drive
System
Service Interval: After the first 5 hours
Every 50 hours—Remove debris from under the belt
cover.
Every 50 hours—Service the blade-drive system.
1. Loosen the 2 screws on the belt-cover-access panel and
remove the panel (Figure 28).
1. Belt-tension spring
2. Adjusting bolt
3. Gap
4. Adjusting nut
19
g019924
1
Figure 27
2. Fuel shutoff valve
3
4
2
1
8
Figure 28
5. Blade-drive belt
6. Wall
7. Belt cover
8. Belt-cover-access panel
2
5
6
7
g019641