Removing The Blades - Toro TurfMaster 22205TE Operator's Manual

1
1. Front of cutting deck
2. Measure at locations A
and B
2. Measure from a level surface to the cutting edges
at locations A and B, (Figure 31), and record both
dimensions.
3. Rotate the blades so that their opposite ends are at
locations A and B.
4. Repeat the measurements in step 2 and record them.
Note: If the difference between the dimensions A and
B obtained in steps 2 and 4 exceeds 3 mm (1/8 inch),
replace the blades; refer to Removing the Blades (page
21) and Installing the Blades (page 21).

Removing the Blades

Replace the blades when they strike a solid object, are out of
balance, bent, or worn. Use only genuine Toro replacement
blades.
1. Use a block of wood to hold each blade steady and turn
the blade bolt counterclockwise as shown in Figure 32.
2
B
B
g016532
3
Figure 31
3. Measure form the cutting
edge to a smooth, level
suface
2. Remove each blade as shown in Figure 33.
1. Spindle (2)
2. Blade driver (2)
3. Inspect the pins on the blade drivers for wear and
damage.
Installing the Blades
1. Install the first blade so that it is horizontal, along with
all mounting hardware as shown in Figure 33.
Note: Tighten the bolt with your fingers.
Important: Position the curved ends of the blades
to point toward the machine housing. Be sure to
nest the raised areas on each blade driver with the
recesses in the head of its corresponding spindle,
and the pins on the other side of each blade driver
with the holes in its corresponding blade.
21
Figure 32
1
G016530
4
Figure 33
3. Blade (2)
4. Blade bolt (2)
2
3