Preparing The Engine; Removing The Machine From Storage - Toro TurfMaster 22205TE Operator's Manual

Preparing the Engine

1. While the engine is still warm, change the engine oil
and the oil filter; refer to Changing the Engine Oil
(page 17) and Changing the Oil Filter (page 18).
2. Remove the spark plug.
3. Using an oil can, add about 30 ml (1 oz), of motor oil
to the engine through the spark-plug hole.
4. Slowly pull the starter rope several times to distribute
oil throughout the cylinder.
5. Install the spark plug but do not connect the wire to
the spark plug. Secure the wire so that it does not come
into contact with the spark plug.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
3. Inspect the spark plug and replace it if it is dirty, worn,
or cracked; refer to the engine operator's manual.
4. Install the spark plug and tighten it to the recommended
torque of 20 N-m (180 in-lb).
5. Perform any needed maintenance procedures; refer to
Maintenance (page 16).
6. Check the engine oil level; refer to Checking the Engine
Oil Level (page 9).
7. Fill the fuel tank with fresh gasoline; refer to Filling the
Fuel Tank with Gasoline (page 9).
8. Connect the wire to the spark plug.
26