Adjusting The Self-Propel Cable; Adjusting The Blade-Brake Cable - Toro TurfMaster 22205TE Operator's Manual

1
1. Transmission tension
spring
2. Transmission
3. BBC belt
9. Remove the transmission tension spring.
10. Remove the transmission belt from the transmission
pulley.
11. Remove the BBC belt.
Note: Hold one of the blades using a glove or a rag
and turn the blade spindle to help remove the BBC belt.
12. To install a new BBC belt, reverse the steps above.
13. Adjust the BBC cable; refer to Adjusting the BBC cable
in Adjusting the Blade-brake Cable (page 23).
Adjusting the Self-propel
Cable
If the machine does not self-propel or tends to creep forward
when you release the control bar, adjust the drive cable.
1. Stop and wait for all moving parts to stop.
2. Loosen the cable-support nut (Figure 38).
1. Cable-support nut
2
Figure 37
4. Transmission belt
5. Tab
1
G019876
Figure 38
3. Slide the cable-support nut toward the machine to
increase the self-propel action; slide the cable-support
nut away from the machine to decrease the self-propel
action.
4. Tighten the cable-support nut.
5. Check the operation for the desired drive control, and
3
repeat the steps above, if necessary.
4
Note: If the machine creeps forward without the
control bar engaged or if the wheels spin when you
lift the rear wheels off the ground, the cable is too
5
tight; loosen the cable-support nut, pull the cable jacket
upward (away from the machine) slightly, and tighten
the cable-support nut.
Note: You may also adjust the maximum ground
speed (when the control bar is fully engaged) as desired.
G019898
Adjusting the Blade-brake
Cable
Adjust the blade-brake cable whenever you install a new cable
or replace the BBC belt.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover (Figure 5) by removing the 4
bolts that hold it to the machine housing.
Note: Save the bolts for installing the belt cover to
the machine housing.
4. Remove any debris from under the belt cover.
5. Loosen the cable-clamp screw (Figure 39).
1. Cable-clamp screw
6. Pull the cable jacket until there is approximately 3 mm
(1/8 inch) of slack.
Note: Do not put tension on the spring.
23
2
1
G019923
Figure 39
2. Blade-brake cable