Changing The Engine Oil Filter - Toro GrandStand 74568TE Operator's Manual

3. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 46).
Figure 46
5. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil
to bring it to the Full mark (Figure 47).
1
3
5

Changing the Engine Oil Filter

Note: Change the engine oil filter more frequently
when operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Place a rag under the oil filter to soak up any spilled
oil.
Important: Spilled oil may drain under the
engine and onto the clutch. Oil spilled on the
clutch may damage the clutch, cause the blades
to stop slowly when the clutch is switched off
and cause the clutch to slip when the clutch is
switched on. Wipe up any spilled oil.
3. Change the engine oil filter (Figure 48).
35
2
4
6
G008796
Figure 47