Motion Control Levers - Toro GrandStand 74568TE Operator's Manual

1. Switch screws
2. Cam
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 70. The gap needs to be an 1/8
inch (3mm) with the right motion control lever in
the neutral, unlocked position.
11. If needed, loosen the screws holding the switch and
adjust the switch (Figure 69 and Figure 70).
Figure 69
3. Nut and bolt
1. Switch
2. 1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Postion for the

Motion Control Levers

Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 71).
Note: Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 71).
48
Figure 70
3. Right motion control lever
in the neutral unlocked
position