Toro GrandStand 74568TE Operator's Manual page 45

6. Loosen the jam nut (Figure 64).
7. Rotate the yoke. To tighten the brake, rotate the
yoke up. To loosen the brake, rotate the yoke down
(Figure 64).
8. Secure the yoke to lower brake lever with the hair pin
cotter pin and clevis pin (Figure 64).
9. Tighten the jam nut (Figure 64).
10. Check the brake operation again; refer to Checking
the Brake.
1
2
3
4
5 6
1. Jam Nut
2. Yoke
3. Clevis pin
11. After the brake is adjusted, the lever switch needs
to be checked.
12. Check the gap between the brake lever and the face
of the switch as shown in Figure 65. The gap needs
to be an 1/8 inch (3mm) with the brake engaged.
13. If needed, loosen the screws holding the switch and
adjust the switch.
Figure 64
4. Hairpin cotter pin
5. Flat washer
6. Lower brake lever
g012873
1. 1/8 inch (3mm) gap
needed between switch
and brake lever
2. Brake lever
3. Switch
g012842
45
5
2
4
3
1
Figure 65
4. Switch button
5. Face of the switch