Table of Contents
Advertisement
Playing back Discs
This section shows you the basics on how to playback a disc.
Most steps in this manual need to be performed using the
supplied remote controller. The relative buttons are usually
indicated at the beginning of a section.
Basic Playback
Preparations
• To view a video disc, switch on your TV set and select the video input the DV-C501 is connected to. See also pages 10, 11
for how to connect the DVD Changer to your TV set.
• If you are also using an amplifier for separate audio playback (see pages 11, 12, 13), switch on the amplifier and select the
input the DV-C501 is connected to.
1
-2
POWER
POWER
-3
STANDBY / ON
or
POWER
2
OPEN/CLOSE
or
OPEN/
CLOSE
3
4
OPEN/CLOSE
14
Connecting to a Wall Outlet and Powering On.
1 Plug the power cable into a suitable wall outlet.
2 Press the POWER button on the main unit to switch it to
Standby mode.
The STANDBY/ON indicator on the main unit lights.
3 Press the STANDBY/ON button on the main unit, or the
POWER button on the supplied remote controller to
switch on the DVD Changer.
The display lights up, and the STANDBY indicator goes
dark.
Press the
OPEN/CLOSE button.
The disc drawer opens, and the disc indicator lights up.
(See "DISC INDICATORS ATTENTION" on page 42.)
Place a disc in the front disc tray (DISC 1).
DISC 2
Be sure to insert the disc with the playback side down.
Placing discs in the remaining disc trays.
Repeatedly press the DISC SKIP
DISC SKIP
on the main unit to rotate the disc drawer in the
direction of the arrow of the button, and place a
disc in each desired tray (1–5).
Press the
OPEN/CLOSE button again.
The disc drawer closes.
Press one of the DISC 1–5 buttons to select the desired
disc on the tray for playback.
CAUTION
Keep your fingers clear of the disc drawer as it is closing to
avoid personal injury.
STANDBY/ON
DISC SKIP /
DISC SKIP
DIMMER
DISPLAY
DISC SELECT
1
2
3
4
5
STANDBY / ON
POWER
POWER
ON
OFF
POWER
DISC 1
/
button
DISC 1—5
NEXT SELECTION
CD PLAY
3
Note:
When you use the DV-C501 for the first
time:
When the DV-C501 is shipped from the
factory, the POWER switch is set to ON
(
ON
OFF
). Therefore, when you
plug in the power cable to the AC outlet,
the STANDBY/ON indicator lights up and
the unit enters Standby mode as
described in Step 1- 2.
Note:
The disc drawer can also be opened when
the DVD Changer is switched off.
Notes:
• The DV-C501 supports two disc sizes.
To avoid damaging your discs or causing
malfunction, be sure to insert the discs
in the correct guide.
• Only use DVD video discs or audio CDs.
Other data carriers may damage your
DVD Changer and/or amplifier/TV set.
Note:
Alternatively, press one of the DISC 1–5
buttons to close the disc drawer and play
the selected disc automatically.
2
SKIP
PLAY
STOP
PAUSE
OPEN/CLOSE
501
DVD / VIDEO CD / CD CHANGER
DV- C
Advertisement
Table of Contents
