Table of Contents
Advertisement
10. To make an adjustment to the cutting units while
backlapping, turn the reels OFF by moving the
Lower Mow/Raise lever rearward; move the
Enable/Disable switch to Disable and turn the
engine OFF. After adjustments have been complet-
ed, repeat steps 5–9.
11. Repeat this procedure for all cutting units to be
backlapped.
Preparation for Seasonal Storage
Traction Unit
1.
Thoroughly clean the traction unit, cutting units
and the engine.
2.
Check the tire pressure. Inflate all tires to 103–138
kPa.
3.
Check all fasteners for looseness; tighten as neces-
sary.
4.
Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
5.
Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted. Repair
any dents in the metal body.
6.
Service the battery and cables as follows:
a.
Remove the battery terminals from the battery
posts.
b.
Clean the battery, terminals, and posts with a
wire brush and baking soda solution.
c.
Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No.
505-47) or petroleum jelly to prevent corro-
sion.
d.
Slowly recharge the battery every 60 days for
24 hours to prevent lead sulfation of the bat-
tery.
12. When you've completed the backlap operation,
return the backlap switch to OFF, lower the seat and
wash all lapping compound off the cutting units.
Adjust the cutting unit reel to the bedknife as need-
ed.
IMPORTANT: If the backlap switch is not
returned to the OFF position after backlapping,
the cutting units will not raise or function proper-
ly.
Engine
1.
Drain the engine oil from the oil pan and replace the
drain plug.
2.
Remove and discard the oil filter. Install a new oil
filter.
3.
Refill the oil pan with 5 l of SAE 15W-40 CD motor
oil.
4.
Start the engine and run at idle speed for two min-
utes.
5.
Stop the engine.
6.
Flush the fuel tank with fresh, clean diesel fuel.
7.
Secure all fuel system fittings.
8.
Thoroughly clean and service the air cleaner assem-
bly.
9.
Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
10. Check anti freeze protection and add a 50/50 solution
of water and Peugeot recommended anti freeze, Part
No. 93-7213, as needed for the expected minimum
temperature in your area.
37
Advertisement
Table of Contents
