Table of Contents
Advertisement
Operating Instructions
Before servicing or making adjustments to the machine,
stop the engine and remove the key from the switch.
STARTING AND STOPPING
1.
Sit on the seat; keep your foot off the traction pedal. Assure
the parking brake is engaged, the traction pedal is in NEU-
TRAL, the throttle is in the SLOW position and the ENABLE/
DISABLE switch is in the DISABLE position.
The engine will not crank over until the glow plug lamp
goes out. Glow plugs must complete their cycle before
the controller will allow the engine to crank.
2.
Turn the ignition switch to ON/Preheat position. An automatic
timer will control preheat for approximately 6 seconds. The
engine will not crank until preheat light goes off. After preheat,
turn the key to START position. CRANK THE ENGINE FOR
NO LONGER THAN 15 SECONDS. Release the key when
the engine starts. If additional preheat is required, turn the key
to the OFF position, then to ON/preheat position. Repeat this
process as required.
CAUTION
WARNING
Figure 14
1.
Seat adjusting lever
2.
Seat adjusting knob
17
Advertisement
Table of Contents
