Table of Contents
Advertisement
•
engage the clutch slowly, and always keep the
machine in gear, especially when travailing
downhill;
•
machine speeds should be kept low on slopes
and during tight turns;
•
stay alert for bumps and hollows and other hid-
den hazards;
•
never mow across the face of the slope, unless
the lawn mower is designed for this purpose.
6. Use care when pulling loads or using heavy equip-
ment.
•
Use only approved drawbar hitch points.
•
Limit loads to those you can safely control.
•
Do not turn sharply. Use care when reversing.
•
Use counterweight(s) or wheel weights when
suggested in the instruction handbook.
7. Watch out for traffic when crossing or near road-
ways.
8. Stop the blades rotating before crossing surfaces
other than grass.
9. When using any attachments, never direct discharge
of material toward bystanders nor allow anyone near
the machine while in operation .
10. Never operate the lawn mower with defective
guards, shields or without safety protective devices
in place.
11. Do not change the engine governor settings or over-
speed the engine. Operating the engine at excessive
speeds may increase the hazard of personal injury.
12. Before leaving the operator's position:
•
disengage the power take-off and lower the
attachments;
•
change into neutral and set the parking brake;
•
stop the engine and remove the key.
13. Disengage the drive to attachments when transport-
ing or not in use.
4
14. Stop the engine and disengage the drive to the
attachment
•
before refueling;
•
before removing the grass catcher;
•
before making height adjustments unless the
adjustment can be made from the operator's
position.
•
before clearing blockages;
•
before checking, cleaning or working on the
lawnmower;
•
after striking a foreign object. Inspect the
lawnmower for damage and make repairs
before restarting and operating the equipment.
15. Reduce the throttle setting during engine runout and,
if the engine is provided with a shutoff valve, turn
the fuel off at the conclusion of mowing.
Maintenance and Storage
1.
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
2.
Never store the equipment with petrol in the tank
inside a building where fumes may reach an open
flame or spark.
3.
Allow the engine to cool before storing in any enclo-
sure.
4.
To reduce the fire hazard, keep the engine, silencer,
battery compartment and petrol storage area free of
grass, leaves, or excessive grease.
5.
Check the grass catcher frequently for wear or dete-
rioration.
6. Replace worn or damaged parts for safety.
7. If the fuel tank has to be drained, this should be
done outdoors.
8. Be careful during adjustment of the machine to pre-
vent entrapment of the fingers between moving
blades and fixed parts of the machine.
9. On multi-bladed machines, take care as rotating one
Advertisement
Table of Contents
