Toro 03800TE Operator's Manual page 16

Enable/Disable Switch (Fig. 10)—Used with lower mow / raise
control lever to operate the reels.
Water-in-the-fuel Light (Fig. 10)—Warns of water in the fuel sys-
tem.
Low Water Level Light (Fig. 10)—Warns that the coolant water
level is low.
Height-of-Cut Selector Knob (Fig. 11)—Turning the knob to the
appropriate setting informs the electronic controller at what height-
of-cut the machine is being operated so desired clip may be
obtained. See section in manual for operating instructions. The knob
is located under the control panel.
Hour Meter (Fig. 11)—Shows total hours the machine has been
operated.
Backlap Switch (Fig. 12)—Used with the lower mow / raise con-
trol lever for backlapping operation. This switch is located under
seat plate. Refer to Cutting Unit Maintenance, Backlapping.
Brake Pedals (Fig. 13)—Two foot pedals operate individual wheel
brakes for turning assistance, parking and to aid better sidehill trac-
tion. A locking pin connects the pedals for parking brake operation
and transport.
Parking Brake Latch (Fig. 13)—A knob on the left side of the
console actuates the parking brake lock. To engage the parking
brake, connect the pedals with the locking pin, push down on both
pedals and pull the parking brake latch out. To release the parking
brake, depress both pedals until the parking brake latch retracts.
Seat (Fig. 14)—Seat adjusting lever allows 10 cm fore and aft
adjustment. Seat adjusting knob adjusts seat for operator's weight.
To adjust the seat fore and aft, pull the lever on the left side of the
seat assembly outward. After moving the seat, release the lever to
lock the seat into position. To adjust for operator's weight, turn the
spring tension knob: clockwise to increase tension, counterclock-
wise to decrease spring tension
16
Figure 11
1. HOC selector knob
2. Hour meter
Figure 12
1. Backlap switch
Figure 13
1. Brake pedals
2. Parking brake latch
3. Locking pin