Preparation For Seasonal Storage; Notes - Toro 30402 Operator's Manual

2. Inspect cutting edges of all blades. Sharpen the
cutting edges if they are dull or nicked. Sharpen only the
top of the cutting edge and maintain the original cutting
angle to make sure of sharpness (Fig. 32). The blade will
remain balanced if same amount of metal is removed
from both cutting edges.

PREPARATION FOR SEASONAL STORAGE

1. Check blades and tighten blade bolts to 85–110
ft–lb.
2. Check and lubricate caster arm bushings.
3. Check and lubricate caster wheel bearings (if so
equipped). Tighten caster wheel nuts to 140–165 ft–lb.
4. Check all fasteners for looseness; tighten as
necessary.
IDENTIFICATION AND ORDERING
MODEL AND SERIAL NUMBER
The model and serial number is on a plate that is
mounted on top front of the center cutting unit. Use
model and serial number in all correspondence and
when ordering parts.
4. To check blade for being straight and parallel, lay
blade on a level surface and check its ends. Ends of
blade must be slightly lower than the center, and cutting
edge must be lower than the heel of the blade. This
blade will produce good quality of cut and require
minimal power from the engine. By contrast a blade that
is higher at the ends than the center, or if cutting edge is
higher than the heel, the blade is bent or warped and
must be replaced.
5. Install blade—sail facing toward cutting unit with
anti–scalp cup, lockwasher and blade bolt. Tighten
blade bolt to 85–110 ft–lb.
5. Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
6. Lightly sand and use touch–up paint on painted
areas that are scratched, chipped, or rusted.
7. Check and relieve tension on drive belts.
8. Clean thoroughly top and underside.
9. Store machine with wing decks lowered.
To order replacement parts from an authorized TORO
Distributor, supply the following information:
1. Model and serial numbers of the machine.
2. Part number, description and quantity of parts
desired.
Note: Do not order by reference number if a parts
catalog is being used; use the part number.
19