15. Appendix
15.1 Appendix A: Printer Status
Blinking
LED
MEDIA
The printer is at pause state. Press PAUSE or CANCEL
to return to normal state.
MEDIA
The media is uninstalled or used up. Load new media to
READY
the printer.
RIBBON
The ribbon is uninstalled or end-of-ribbon occurred.
READY
Load new ribbon to the printer. If you just use thermal
media set printer driver to D/T.
READY
The format or baud rate of the RS232 communication is
inconsistent between the printer and host.
The cutter cannot cut off the media: check the media
and cutter.
The printer buffer is full caused by the loaded soft
fonts, graphics or forms. Check the format of these
data. Call for service.
Description
57
15.2 Appendix B: Stand-Alone Operation
Stand-Alone operation for keyboard and barcode reader
Apart from related hardware devices and PPLB emulation, in
order to use keyboards and barcode readers (scanner) you
should follow apply with PrinterKee.
15.3 Appendix C: Dispenser Kit installation
1.
Turn off the power switch.
2.
Remove the top cover and middle cover.
Top Cover
H Cover
Middle Cover
Chassis 2
3.
Remove gear (27) and (31).
4.
Plug spring–peeler (83) into the right hole on chassis 2 and
Pull
Screw
58
Need help?
Do you have a question about the COMPACT SERIES and is the answer not in the manual?