Appendix; Appendix A: Printer Status; Appendix B: Stand-Alone Operation; Appendix C: Dispenser Kit Installation - Meteor Manuale Compact 400 Plus Manual

15. Appendix

15.1 Appendix A:
Printer Status
Blinking
LED
MEDIA The printer is at pause state. Press PAUSE or CANCEL
to return to normal state.
MEDIA The media is uninstalled or used up. Load new media to
READY the printer.
RIBBON The ribbon is uninstalled or end-of-ribbon occurred.
READY Load new ribbon to the printer. If you just use thermal
media set bit 1 of DIP switch to OFF position.
READY The format or baud rate of the RS232 communication is
inconsistent between the printer and host.
The cutter can not cut off the media, check the media
and cutter.
The printer buffer is full caused by the loaded soft
fonts, graphics or forms. Check the format of these
data. Call for service.
Description
65
www.meteorbarcode.it - info@meteorbarcode.it
15.2 Appendix B:
Stand-Alone Operation
Stand-Alone operation for keyboard and barcode reader
Apart from related hardware devices and PPLB emulation, in
order to use keyboards and barcode readers (scanner) you
should follow apply with ArgoKee.
15.3 Appendix C:
Dispenser Kit installation
1. Turn off the power switch.
2. Remove the top cover and middle cover.
Top Cover
H Cover
Middle Cover
Chassis 2
Pull
Screw
66