Adjusting The Position Of The Thread Receiver - JUKI MF-7700D Series Engineer's Manual

(4) Adjusting the position of the thread receiver

1. Position of the needle bar thread take-up thread receiver (in case of standard seams)
(1) It is the standard that the height of needle bar thread take-up thread receiver
bottom end of thread hole to the center of needle bar thread take-up
bar thread take-up thread receiver
2. Position of the rocking thread take-up thread receiver (in case of soft seams)
(In case thread is not passed through needle bar thread take-up
(1) It is the standard that the height of rocking thread take-up receiver
surface of rocking thread take-up receiver
rocking thread take-up
Standard Adjustment
when the needle bar is in its lowest position.
is in the range of the center to the top end of thread hole
when rocking thread take-up
– 12 –
aligns with the top surface of needle
Thread hole
Center of hole
This range
To align
)
is in the position where the top
is in its lowest position.
This range
is in the position where the
of