JUKI MF-7700D Series Engineer's Manual page 75

Adjustment Procedure
By adjusting eccentric cam B
(at the time of shipment from the factory), can be adjusted within the
range of 1.4 to 3.3mm.
(1) Remove the pulley cover and the pulley.
(2) Loosen two screws at eccentric cam B
For tape feeding of 0.6 to 1.5mm:
Where the notch of eccentric cam B
side of screw , fix eccentric cam B
For tape feeding of 1.4 to 3.3mm:
Where the notch of eccentric cam B
side of screw , fix eccentric cam B
, the amount of tape feed, 0.6 to 1.5mm
.
comes in contact with the right
by tightening its screw.
comes in contact with the left
by tightening two screws.
– 71 –
Results of Improper Adjustment
E10/MD10