Replacing The Headlight Bulb; Preparing The Snowthrower For Storage - Toro 38650 Operator's Manual

www.Toro.com for additional service information or have
an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 58).
Figure 58
2. Turn the base of the bulb counterclockwise until it
stops (Figure 59).
Figure 59
3. Remove the bulb straight out from the back of the
headlight (Figure 60).
Figure 60
4. Insert a new bulb into the back of the headlight (Figure
61).
Figure 61
5. Turn the base of the bulb clockwise until it is snug
(Figure 62).
Figure 62
6. Insert the wire connector straight into the back of the
headlight until it is securely in place (Figure 63).
Figure 63
Storage
•
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the snowthrower in an enclosure
near an open flame.
•
Allow the engine to cool before storing it.
Preparing the Snowthrower
for Storage
1. On the last refueling of the year, add fuel stabilizer to
fresh fuel as directed by the engine manufacturer.
2. Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3. Loosen the hose clamp that secures the fuel line to the
valve and slide the fuel line off the fuel shutoff valve.
4. Open the fuel shutoff valve and allow the fuel to drain
out of the fuel tank into an approved fuel container.
21