Table of Contents
Advertisement
Figure 59
2. Loosen the bolt on the cable clamp (Figure 60).
Figure 60
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 60 and Figure 61).
Figure 61
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 61).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
6. Install and secure the gear cover.
2. Cable clamp
2. Gear teeth
Replacing the Drive Belts
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.
Replacing the Headlight Bulb
Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 62).
2. Turn the base of the bulb counterclockwise until it
stops (Figure 63).
3. Remove the bulb straight out from the back of the
headlight (Figure 64).
4. Insert a new bulb into the back of the headlight
(Figure 65).
27
Figure 62
Figure 63
Figure 64
Advertisement
Table of Contents
