Checking And Adjusting The Auger/Impeller Cable - Toro 38650 Operator's Manual

Figure 45
1. Pin
If the left hand (traction) cable is not properly adjusted,
do the following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3. Tighten the jam nut (Figure 46).
Figure 46
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the first
2 operating hours, then yearly thereafter.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover (Figure 47).
2. Turnbuckle
Figure 47
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1/16 inch (1.5 mm) (Figure 48).
Figure 48
1. Tab
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut (Figure 49).
Figure 49
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 49).
7. Adjust the turnbuckle until you obtain the proper gap.
18
2. Turnbuckle