Table of Contents
Advertisement
Adjusting the Discharge
Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the
fastener on the
gear cover, lift the
front of the cover
up, and slide it
back and out of the
way.
m–7789
2. Loosen the bolt on the cable clamp (A).
3. Grasp the cable conduit (B) and move it toward
the front of the machine until the discharge chute
latch (C) fully engages the teeth of the gear (D).
D
Note: The latch is spring loaded and will naturally
move into the teeth of the gear.
4. Remove any slack in the cable by pulling the
cable conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.
18
A
B
m–7791
C
m–7790
3351-198 Rev A
Replacing the Headlight
Bulb
Use a GE 892 16W halogen light bulb. Do not
touch the bulb with your hands or allow dirt or
moisture to come into contact with the bulb.
1. Remove the
wire connector
from the back of
the headlight.
2. Turn the base
of the bulb
counterclockwise
until it stops.
3. Remove the
bulb straight out
from the back of
the headlight.
4. Insert a new
bulb into the back
of the headlight.
5. Turn the base
of the bulb
clockwise until it is
snug.
6. Insert the wire
connector straight
into the back of the
headlight until it is
securely in place.
m-7017
m-7012
m-7013
m-7014
m-7015
m-7017
Advertisement
Table of Contents
