Programming A Master Power Key With Instant Channel Selection - One for All URC-8910 User Manual

5.
6.
Now when you press M1, you will instantly see cable channel 71 on
your TV set.
Programming A Master Power Key With Instant
Channel Selection
A macro key can be programmed to turn on and off your devices as
well. For example, let's set up a sequence that will turn on the TV
and tune it to channel 3, and then turn on the cable converter and
tune it to a premium channel (e.g., 11).
NOTE: This example assumes all equipment is turned off and that the TV is
connected through the cable converter with TV tuning set to channel 3.
1.
2.
Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
TV - 7- 1
NOTE: If you have access to over 100 channels, add a 0
before the channel numbers (e.g., 0-7-1). If the original
remote control required pressing an
channel, also press the Enter key after the channel number
(e.g., 0-7-1-ENTER).
NOTE: An [ERROR] message, followed by [MAX = 15] alerts
you that the macro sequence must be 15 keys or less.
After pressing the first key (in the macro sequence),
you will see the display change to [SEL TO END]. This
message acts as a reminder to use SELECT to end the
sequence (see next step).
To end the macro sequence, press and hold SELECT
until you see [SUCCESS] appear in the display,
followed by [EXIT SETUP]. The URC-8910 remote
control will automatically exit the programming
mode and return to normal operation.
Perform steps 1 through 4 of the previous section,
Programming A Favorite Channel on page 34.
However, this time in step 4, substitute another open
macro key (e.g., M2).
Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
CBL - POWER - TV - POWER- 0- 3 - CBL- 1- 1
NOTE: If you have access to over 100 channels, add an 0
before each set of channel numbers (e.g., 0-0 -3 and 0-1-1).
If the original remote control required pressing an
to change the channel, also press the Enter key after each
channel number (e.g., 0-0-3-ENTER and 0-1-1-ENTER).
22
Enter
key to change the
Enter
continued on next page...
key