USING THE HOME THEATER MODE
About Device Groups (continued)
The default Device Group settings from the factory is:
(1) Playback Group:
(2) Audio Group:
(3) Channel Group:
(4) Menu Group:
(5) PIP Group:
Programming The Home Theater Mode
For example, let's assume you have a TV, a cable converter, and a VCR
in your home theater system.You can set up the Home Theater mode
so that selected controls are assigned to these devices as follows:
On the URC-8910 remote control, press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].
NOTE: The device, its code, and time are examples. Your
remote control settings may be different.
NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse. You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.
key three times until you see the display
change to [THEATER].
NOTE: If you go past [THEATER], press the
more times to return to it.
Press SELECT once to begin programming.You will
see the display change to [PLAYBACK].
NOTE: The program will automatically step through each
Control Group (from Playback to PIP) as you perform steps
3 through 7. However, you can use the
gate to a specific group to make further changes.
key one or
keys to navi-