Operating The Home Theater Mode
After programming the Home Theater mode (see the previous
section), you simply activate it by pressing HOME THEATER once.
Instantly, groups of URC-8910 remote control keys will be assigned
to their programmed devices.
For the above example (in the previous section), pressing HOME
THEATER once would assign the following keys to the VCR, TV, and
Cable Converter: CH+, CH-, (Keypad) 0 ~ 9, ENTER, LAST, SLEEP,
b. Press SELECT once to accept the assignment in
step 7a.You will see the display change to the first
Control Group assignment, [PLAYBACK]).
At this point, all Control Groups have been assigned.
To change an assignment, use the
navigate to a specific group and make changes by
repeating the appropriate step (3, 4, 5, 6, or 7).
Otherwise, to exit programming, press and hold
SELECT until you see [SUCCESS] appear in the dis-
play, followed by [EXIT SETUP]. The URC-8910
remote control will automatically exit the program-
ming mode and return to normal operation.
PLAY, STOP, FF, REW, F.FWD, F.REW, PAUSE, and REC
VOL+, VOL-, MUTE, PIP, MOVE, and SWAP
INFO, TV/VID, MENU, GUIDE, Cursor Controls (
, ), SELECT, and EXIT