PROGRAMMING TV/VCR COMBO CONTROL
Perform the following instructions to control a TV/VCR Combo:
Turn on the TV/VCR Combo and insert a video
NOTE: Please read steps 2 through 9 completely before pro-
ceeding. Highlight or write down the codes and device you
wish to program before starting step 2.
On the URC-8910 remote control, press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].
NOTE: The device, its code, and time are examples.Your
remote control settings may be different.
NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse. You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.
Press SELECT once to begin programming.You will
see the display change to the last-selected device
and its current code (e.g., TV and 0051)
Press VCR once.You will see the display change to
[VCR] and its current code.
Use the Setup Codes For TV/VCR Combos (on
page 22) to locate the type of device and brand
name. Then use the keypad to enter the first four-
digit code for your device and press SELECT once.
For example, to enter the first Sony TV/VCR Combo
code on page 23, press 0 four times and then
If the code is entered correctly, you will see the
NOTE: If your TV/VCR Combo has a separate TV code, you
will also need to perform step 6.