PROGRAMMING FAVORITE CHANNEL SCAN
key four times until you see the display
change to [FAV CHAN].
NOTE: If you go past [FAV CHAN], press the
more times to return to it.
Press SELECT once to begin programming.You will
see the display change to the last-selected device
Select a mode (e.g., TV) for favorite channel
scanning and press it once. Then press Press SELECT
once.You will see the display change to [FAV].
Use the keypad to enter a favorite channel number
(e.g., 031). The display will show your entry.
NOTE: If the original remote control required pressing an
Enter key to change the channel, also press the ENTER key
after the channel number (e.g., 0-3-1-ENTER). However, the
display will not show the ENTER key.
NOTE: If you made a mistake during entry, press any
number key one or more times until you see the display
clear out. Then try entering the correct numbers again.
Press SELECT once.You will see the display clear out,
ready for your next entry.
If desired, repeat step 5 for each favorite channel to
be stored, up to a total of 10 channels.
NOTE: Once the tenth channel is entered, the remote control
will automatically exit programming.
(Optional) To exit programming, press and hold
SELECT until you see [SUCCESS] appear in the
display, followed by [EXIT SETUP]. The URC-8910
remote control will automatically exit the program-
ming mode and return to normal operation.
key one or