Service Interval Chart; Lubrication; Greasing The Bearings And Bushings - Toro 03606A Operator's Manual

Service Interval Chart

decal125-2927
Figure 61
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you do any maintenance.

Lubrication

Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
lubricate all grease fittings for the bearings and
bushings after every 50 hours of operation with No.
2 lithium grease. Lubricate bearings and bushings
immediately after every washing, regardless of the
interval listed.
g021216
The grease fitting locations and quantities are as
Figure 62
follows:
•
Pump-drive shaft (3) (Figure 62)
46