Toro 41164 Operator's Manual page 21

Flowmeter
The flowmeter measures the flow rate of the fluid for use
by the Spray Prot system (Fig. 17).
Boom Valves
These valves turn the three booms on or off (Fig. 17).
Boom Bypass Valves
The boom bypass valves redirect the fluid flow for a boom
to the tank when you turn off the boom section. You can
adjust these valves to ensure that the boom pressure
remains constant no matter how many booms are on. Refer
to Adjusting the Boom Bypass Valves, page 25.
Agitation Control Valve
This valve is located on the right side of the tank (Fig. 18).
Turn the knob on the valve to the 9 o'clock position to turn
on the tank agitation and to the 3 o'clock position to turn
off the tank agitation.
2
1
Figure 18
1. Agitation control valve
For agitation to work, the pump must be on and the engine
must be running above an idle. If you stop the sprayer and
need agitation on, place the range selector in the Neutral
position, set the parking brake, press the accelerator pedal
to the floor, and turn the neutral engine speed control on.
m–7697
2. Pressure gauge
21
Pressure Gauge
The pressure gauge is located to the right of the tank
(Fig. 18). This gauge shows the pressure of the fluid in the
system in psi and kPa.
Pump
The pump is located near the front of the tank on the right
side (Fig. 19).
2
Figure 19
1. Pump
Tank Drain Handle
The tank drain handle is located on top of the tank
(Fig. 20). Pull the handle out to drain the tank.
Important
Pull the handle gently out until it stops. Do
not pull too hard or you may damage it.
1
Figure 20
1. Tank drain handle
1
2. Grease fitting