Table of Contents
Advertisement
WARNING
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable stick-
ing or stiffness.
Open the throttle lever housing.
V06I03Y
1. Remove screws
Slide the rubber protector to expose
the cable adjuster.
Unscrew the lock nut of the cable ad-
juster then screw in the adjuster to re-
lease the cable tension.
1
V06I0TY
1. Rubber protector
2. Cable adjuster
Remove the cable from the throttle
lever.
_____________________
102
1
2
V06I04Y
1. Throttle handle housing
2. Throttle cable
NOTE:
Slide cable in clip slot and re-
move the end of cable from clip.
Remove the carburetor cap on top of
the carburetor. Place the carburetor
cap far from carburetor body.
Install the cable luber (P/N 529 035
738) on the cable.
Insert the needle of spray can in the
cable luber hole.
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
NOTE:
Place a rag around the cable
luber to prevent the lubricant splash.
Add lubricant until it runs out at carbu-
retor end of the throttle cable.
Let the cable hang during approxi-
mately 15 minutes or until no lubricant
flows out of cable.
Reinstall carburetor cap.
Reinstall and adjust the cable.
Throttle Lever Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
2
1
Hide quick links:
Advertisement
Table of Contents
