Table of Contents
Advertisement
WARNING
Place ignition switch to OFF before
checking, adjusting or lubricating
the drive chain.
CAUTION:
Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
Inspection
This ATV is equipped with O-ring
sealed permanently greased pins and
rollers. Before operating the vehicle,
always inspect the drive chain.
Check the free play of drive chain and
adjust if necessary.
Check for damage or missing O-ring or
rollers.
Cleaning and Lubrication
CAUTION:
Never wash the chain
with a high pressure washer or
gasoline. Damage to the O-ring will
result, causing premature wear and
drive chain failure.
Clean the side surfaces of the chain
with a dry cloth.
NOTE:
Do not brush chain.
Lubricate only with an approved O-ring
chain lubricant.
chain lubricants may contain solvent
which could damage the O-rings.
Adjustment
NOTE:
Never adjust drive chain with
the driver seated on the vehicle. Re-
move all load on vehicle.
Select a level surface and set trans-
mission to NEUTRAL.
Loosen chain tensioner lock bolts.
Other commercial
_____________________
V06H0QY
1. Chain tensioner lock bolts
Insert adjuster lock through sprocket
hub and into chain tensioner.
V06H0RY
1. Drive chain
2. Adjuster lock
3. Sprocket hub
4. Chain tensioner
Adjust chain deflection by slowly mov-
ing the ATV forward so any slack that
may have previously been on the un-
der part of the chain is now on the top
of the chain. The bottom part of the
chain should be taught during adjust-
ment.
The deflection should be between 20
and 30 mm (3/4 and 1-1/8 in).
1
4
3
2
1
99
Hide quick links:
Advertisement
Table of Contents
