Safety instructions for installation
The appliance must only be installed and connected to the electricity supply
by a suitably qualified and competent person in strict accordance with current
national and local safety regulations.
Fit the wall units and rangehood before fitting the CombiSet to avoid damaging
it.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any splashbacks must be of heat-resistant
material as well.
The CombiSet must not be installed over a fridge, fridge-freezer,
freezer, dishwasher, washing machine, washer-dryer or tumble dryer.
This cooktop must not be installed above ovens unless these
have a built-in cooling fan.
After installation, the connection cable must not come into
contact with any moving kitchen component (e.g. a drawer) or be
subject to mechanical obstruction which could damage it.
Observe carefully the safety clearances listed on the following
pages.
All dimensions in this instruction booklet are given in mm.
40