Remote Controller (Optional) - Takagi GS-2000W-AU Installation Manual

REMOTE CONTROLLER (OPTIONAL)

The water heater can be installed with up to three remote controllers. Each remote controller has two
functions which can adjust the set temperature and indicate the error code on the remote controller.
• The set temperature can be adjusted only by a remote controller which has the priority setting (when a
remote controller has the priority setting, PRIORITY lamp on the remote controller is lit), and the other
remote controller(s) display the set temperature. If you desire to transfer the priority setting, you can
transfer it by pressing the PRIORITY button only when there is no water flow through the water heater.
(Default set temperature is 40 °C.)
• All water heater models have a self diagnostic function for safety and convenience when troubleshooting.
If there is a problem with the installation or the unit, it will display a numerical error code on the
remote controller (or the LED of the computer board will blink.)
MAIN REMOTE CONTROLLER (MODEL: MC100-AU3-TP)
MC100-AU3-TP
• Location-
clean locations (such as kitchen) due to NO water resistant. Be
careful of installation location.
• The controller can adjust the output water temperature within the
range of 37 °C to 55 °C.
• The temperature options are:
37 °C, 38 °C, 39 °C, 40 °C, 41 °C, 42 °C, 43 °C, 44 °C, 45 °C, 46 °C, 47
°C, 50 °C, 55 °C.
• When "BURNER ON" lamp is lit, the set temperature can not be
adjusted to 55 °C. If you desire to set it to 55 °C, you should close
the hot water tap.
SHOWER CONTROLLER (MODEL: FC100-AU3-TP)
AND ENSUITE CONTROLLER (MODEL: SC100-AU3-TP)
• FC100-AU3-TP
ant, however should not be positioned where they can be splashed
directly and there should be caulking between the surface of the
wall and the controller.
• FC100-AU3-TP
SC100-AU3-TP
• These remote controllers allow the output temperature from the
water heater to be adjusted within the range of 37 °C to 50 °C.
• The temperature options are:
37 °C, 38 °C, 39 °C, 40 °C, 41 °C, 42 °C, 43 °C, 44 °C, 45 °C, 46 °C,
47 °C, 50 °C.
• When BURNER ON lamp is lit, the set temperature can not be ad-
justed to 42 °C or over. If you desire those temperatures, you should
close the hot water tap.
must be installed in dry, shaded and
SC100-AU3-TP
and
is installed such as the main bathroom, and
is installed such as the ensuite bath room.
controllers are water resist-
14
MC100-AU3-TP
Main
FC100-AU3-TP
Shower
SC100-AU3-TP
Ensuite