Safety Guidelines - Takagi GS-2000W-AU Installation Manual

Ensure the following safety instructions are read and understood before commencing installation.
• Installation and service must be performed by a qualified installer (for example, a licensed
plumber or gas fitter).
• The installer (licensed professional) is responsible for the correct installation of the water
heater and for compliance with all relevant National, State or local regulations.
• The water heater must be installed OUTDOORS ONLY. DO NOT install the water heater
indoors.
1. Carefully plan where you intend to install the Water Heater. Please ensure:
• The water heater will have enough combustible air and proper ventilation.
• Locate the water heater where water leakage will not damage surrounding areas.
2. Check the rating plate and gas type label for the correct GAS TYPE, GAS PRESSURE, WATER PRESSURE
and ELECTRIC RATING.
*If this unit does not match your requirements, do not install and consult with MANUFACTURER.
3. If any problem should occur, turn off all hot water taps and turn off the gas. Then call a trained
technician or the Gas Company or the manufacturer.
• Water temperatures above 50
the disabled and the elderly are at a high risk of being injured. Feel the water temperature
before bathing or showering. Do not leave children, disabled persons, or the elderly
unsupervised. The Australian Standards AS 3498 gives full details of the requirements for
supply of controlled temperature to ablution outlets (bathrooms) and is required to be
conformed to under all plumbing codes within Australia.
• Do not store or use gasoline or other flammables, vapors, or liquids in the vicinity
• Do not reverse the water and/or gas connections as this will damage the gas
• Do not use this appliance if any part has been in contact with or been immersed
• Do not disconnect the electrical supply if the ambient temperature will drop
Prohibited

SAFETY GUIDELINES

can cause severe burns or death from scalding. Children,
°C
of this appliance.
valves and can cause severe injury or death. Follow the diagram on p. 10 and 12
when installing your water heater.
in water. Immediately call a licensed plumber, a licensed gas fitter, or a professional
service technician to inspect and/or service the unit if necessary.
below freezing. The Freeze Prevention System only works if the unit has electrical
power. The warranty will not be covered if the heat exchanger is damaged due to
freezing. Refer to the section on the Freeze Prevention System on p. 20 for more
information.
WARNING
GENERAL
WARNING
6