Electrical Connection - Takagi GS-2000W-AU Installation Manual

1. The water heater must be electrically grounded. Do not attach the
ground wire to either the gas or water piping.
2. The water heater requires an AC 240V 50Hz electrical power supply and
draws a current of 0.8A.
3. The weather-proof power point should be no more than 1 metre from
the base of the water heater for easy access.
4. Install so that the electrical power can be switched off if necessary.
5. If the cord supplied with this appliance must be replaced, it must be
replaced with appliance wiring material supplied by the Manufacturer.
When servicing or replacing parts within the water heater, label all wires prior to disconnection
to facilitate an easy and error free reconnection. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.

ELECTRICAL CONNECTION

WARNING
13
Weather-proof
Power Point