Table of Contents
Advertisement
6. Lower the loader arm.
Using Attachments
Connecting an Attachment
Important
Use only Toro-approved, Dingo TX 413
attachments. Attachments can change the stability and the
operating characteristics of the traction unit. The warranty
of the traction unit may be voided if used with unapproved
attachments.
Important
Before installing the attachment, ensure
that the mount plates are free of any dirt or debris and that
the pins rotate freely. If the pins do not rotate freely,
grease them; refer to Greasing the Traction Unit, page 30.
1. Position the attachment on a level surface with enough
space behind it to accommodate the traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position mount plate into the upper lip of the
attachment receiver plate (Fig. 23).
2
Figure 23
1. Mount plate
5. Raise the loader arm while tilting back the mount plate
at the same time.
Important
The attachment should be raised enough to
clear the ground, and the mount plate should be tilted all
the way back.
6. Stop the engine.
7. Engage the quick attach pins, ensuring that they are
fully seated in the mount plate (Fig. 24).
Important
If the pins do not rotate to the engaged
position, the mount plate is not fully aligned with the
holes in the attachment receiver plate. Check the receiver
plate and clean it if necessary.
1
m–7504
2. Receiver plate
19
Warning
If you do not fully seat the quick attach pins
through the attachment mount plate, the
attachment could fall off of the traction unit,
crushing you or bystanders.
Ensure that your quick attach pins are fully
seated in the attachment mount plate.
3
1
2
Figure 24
1. Quick attach pins (shown
in engaged position)
Connecting the Hydraulic Hoses
If the attachment requires hydraulics for operation,
connect the hydraulic hoses as follows:
1. Stop the engine.
2. Move the auxiliary hydraulics lever forward,
backward, and back to neutral to relieve pressure at the
hydraulic couplers.
3. Move the auxiliary hydraulics lever into the detent
position.
4. Remove the protective covers from the hydraulic
couplers on the traction unit.
5. Clean all foreign matter from the hydraulic couplers.
m–5919
2. Disengaged position
3. Engaged position
Advertisement
Table of Contents
