Table of Contents
Advertisement
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Accessing the Engine and
Internal Components
Before opening any of the covers, stop the engine and
remove the key. Allow the engine to cool before opening
any covers.
Opening the Hood
1. Turn the hood latch clockwise and swing the hood up
(Fig. 30).
2
Figure 30
1. Hood latch, turn clockwise
Closing the Hood
Lower the hood and secure it by pushing down on the
front of the hood until it locks in place.
Caution
1
m–7522
2. Hood, swing up
23
Opening the Rear Access Cover
1. Pull out and forward on the latches on both sides of the
traction unit (Fig. 31).
Figure 31
2. Swing the rear access cover down and pull it away
from the traction unit (Fig. 31).
Figure 32
Closing the Rear Access Cover
1. Insert the bottom of the rear access cover into the
frame and swing it up.
2. Place the latches over the locking brackets on each
side and secure them (Fig. 31).
m–7474
m–7475
Advertisement
Table of Contents
