Checking The Oil Level; Removing Debris From The Traction Unit; Checking The Hydraulic Fluid - Toro 22308 Dingo TX 413 Operator's Manual

Important This space in the tank allows gasoline to
expand. Do not fill the fuel tank completely full (Fig. 4).
5. Install the fuel tank cap securely.
6. Wipe up any gasoline that may have spilled.

Checking the Oil Level

1. Park the traction unit on a level surface, lower the
loader arm, and stop the engine.
2. Remove the key and allow the engine to cool.
3. Clean around the oil dipstick (Fig. 5).
1
m–7470
Figure 5
1. Oil filler hole
4. Remove the dipstick and wipe the end clean (Fig. 5).
5. Slide the dipstick fully into the dipstick tube without
threading it into the filler neck (Fig. 5).
6. Pull the dipstick out and look at the end. There should
be oil on the dipstick (Fig. 6).
m–7488
Figure 6
Oil Pan Cross-section
1. Maximum oil level
2
2. Oil dipstick
1
2
2. Low oil level
7. If there is no or little oil on the dipstick, add 10w30
engine oil to the filler hole until it comes to the edge
of the filler hole (Fig. 5 and 6).
8. Replace the dipstick.
Removing Debris from the
Traction Unit
Important
Operating the engine with blocked screens,
dirty or plugged cooling fins, and/or cooling shrouds
removed, will result in engine damage from overheating.
1. Park the traction unit on a level surface, lower the
loader arm, and stop the engine.
2. Remove the key and allow the engine to cool.
3. Open the hood; refer to Opening the Hood, page 23.
4. Clean any debris from the front and side screens.
5. Wipe away debris from the air cleaner.
6. Clean any debris build-up on the engine and in the oil
cooler fins with a brush or blower.
Important It is preferable to blow dirt out, rather than
washing it out. If water is used, keep it away from
electrical items and hydraulic valves. Do not use a
high-pressure washer. High-pressure washing can damage
the electrical system and hydraulic valves or deplete
grease.
7. Clean debris from the cooler fan grill on the hood.
8. Close the hood.

Checking the Hydraulic Fluid

Check the hydraulic fluid level before the engine is first
started and after every 25 operating hours.
Hydraulic Tank Capacity: 10 US gallons (37.8 l)
Use 10W-30 or 15W-40 detergent, diesel engine oil (API
service CH-4 or higher).
1. Remove the attachment, if one is installed; refer to
Removing an Attachment, page 20.
2. Park the traction unit on a level surface, lower the
loader arm, and fully retract the tilt cylinder.
3. Stop the engine, remove the key, and allow the engine
to cool.
4. Clean the area around the filler neck of the hydraulic
tank (Fig. 7).
5. Remove the cap from the filler neck (Fig. 7).
12