Table of Contents
Advertisement
Product Overview
1. Vibratory-plow body
2. Blade (several optional
blade styles are available)
3. Puller (several optional
puller styles are available)
Specifications
Note: Specifications and design are subject to change
without notice.
Width
Length
Height
Weight
Hydraulic motor displacement
Plow cycles
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Figure 3
4. Gauge-rod assembly
5. Coulter
6. Mounting plate
73.6 cm (29 inches)
89 cm (35 inches)
60 cm (24 inches)
181.5 Kg (400 lb)
1.27 in
3
/rev (20.8 cc)
2,000 VPM
Operation
Refer to your traction unit Operator's Manual for more
information on installing and removing attachments on your
traction unit.
Important: Always use the traction unit to lift and move
the attachment.
Installing a Blade
Toro offers several different blades and pullers. Purchase a
blade and puller from your Authorized Toro Dealer dealer.
WARNING
g005037
The blade is sharp and can swing during installation
and removal, cutting, pinching, or crushing hands
or feet.
Wear gloves and work boots and securely hold the
blade.
1. Raise the plow about 1 m (39 inches) off of the ground
and install the cylinder lock(s).
2. Stop the engine and remove the key.
3. Remove the two click pins from the clevis pins in the
blade bracket, then remove the clevis pins
and the existing blade (if installed).
1. Click pin
2. Clevis pin
4. Slide the new blade into the blade bracket and secure
it at the desired depth (a change in mounting holes
changes the depth by 7.6 cm (3 inches), using the clevis
pins and click pins removed previously
6
(Figure
Figure 4
3. Blade
(Figure
4)
g005025
4).
Advertisement
Table of Contents
