Fuses - BOMBARDIER outlander max 650 efi 2006 Operator's Manual

TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch
OFF before replacing a defective
bulb.
Always check light operation after re-
placement.
Headlamps
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
Remove cover screws.
vmo2006-005-043_a
1. Screws
2. Holder
_____________________
120
Remove rubber protector over head-
lamp housing.
vmo2006-005-040_a
1. Rubber protector
2. Headlamp housing
Unplug connector from headlamp.
NOTE: Press small locking tab to un-
lock connector then pull on connector.
vmo2006-005-041_a
PUSH ON LOCKING TAB TO UNLOCK
CONNECTOR
NOTE: Concerning the following illus-
trations, the front fascia has been re-
moved from the vehicle for a better
comprehension.
Press the spindle then push it on the
side to unlock headlamp bulb.