Pop - Omron CS CJ1W-ETN21 Operation Manual

Common Protocol Settings
Note
1-4-2

POP

Item
IP Address Set the IP address for the SMTP server
used for sending mail.
This setting is enabled only when "IP
address" is selected as the method for
specifying the server.
Host name Set the host domain name (i.e., the host
name) for the SMTP server that is to be
used for sending mail.
This setting is enabled only when "host
name" is selected as the method for speci-
fying the server.
Port No. Set the port to be used for connecting to the
SMTP server that is to be used for sending
mail.
This setting does not normally need to be
changed.
Use POP before Select whether or not to use the mail receiv-
SMTP ing method (POP before SMTP) in which
the POP server must be accessed (to
receive mail) before the SMTP server is
accessed (to send mail).
The "POP before SMTP" is an authentication function required when sending
mail (using the SMTP server). Normally, account name and password authen-
tication is performed with the POP server because there isn't an authentica-
tion process in the SMTP server. Most ISPs (Internet Service Providers) use
the "POP before SMTP" authentication method to verify users sending e-mail.
Always enter the POP server settings when using the Mail Receive Function.
Also, set the POP server settings when using "POP before SMTP" in the Mail
Send Function.
Contents
Section 1-4
Default
0.0.0.0
None
0
(No. 25 is used.)
Disabled
5